Overview
This estimates the studs and plate lumber for a wall from its length, stud spacing and openings. Use it for a material list and a rough budget.
Enter the length and spacing, then count door and window openings and any corners or wall ends with extra studs.
Worked examples
| Inputs | Result |
|---|---|
| UnitsImperial (ft, miles, gallons)Wall length (ft or m)20Stud spacing16 in on centerDoor and window openings1Corners or wall ends with extra studs2 | Studs needed: 23Plates: 60 linear ft (one bottom, two top)Studs on spacing: 16Add 10% for waste, and follow local codes |
Show 2 more examples
| UnitsImperial (ft, miles, gallons)Wall length (ft or m)24Stud spacing24 in on centerDoor and window openings0Corners or wall ends with extra studs0 | Studs needed: 13Plates: 72 linear ft (one bottom, two top)Studs on spacing: 13Add 10% for waste, and follow local codes |
| UnitsImperial (ft, miles, gallons)Wall length (ft or m)12Stud spacing16 in on centerDoor and window openings2Corners or wall ends with extra studs2 | Studs needed: 20Plates: 36 linear ft (one bottom, two top)Studs on spacing: 10Add 10% for waste, and follow local codes |
Studs needed by wall length
With the calculator's starting values, the studs needed is 23. The table shows how it changes with the wall length.
| Wall length (ft) | Studs needed |
|---|---|
| 10 | 16 |
| 12.5 | 18 |
| 15 | 20 |
| 17.5 | 22 |
| 20starting value | 23 |
| 22.5 | 25 |
| 25 | 27 |
| 27.5 | 29 |
| 30 | 31 |
Other inputs: Units: Imperial (ft, miles, gallons) · Stud spacing: 16 in on center · Door and window openings: 1 · Corners or wall ends with extra studs: 2. Change them in the calculator above for your own numbers.
How it works
Base studs are the length divided by spacing, plus one to finish the run. Each opening adds about three studs, and each corner about two. Plates assume one bottom plate and a double top plate. Real framing varies with headers, cripples and local codes, so follow your plans or building inspector.
The formula
| spacing | Inches on center |
| plates | 3 × wall length |
Practical tips
- A 20 ft wall at 16 in on center has 16 base studs, or 23 with one opening and two corners.
- Add about 10% for waste, warps and mistakes.
- Sheet goods fit best when studs are on 16 or 24 in centers.
Frequently asked questions
Is one stud per foot a good rule?
It’s a popular shortcut for 16-inch spacing that roughly allows for openings and corners.
Should I use 16 or 24 inch spacing?
It depends on loads, wall height and code. Load-bearing walls usually use 16 inches.