Overview

Rebar holds a slab together when it cracks. This calculator lays out a square grid of bars for a rectangular slab and tells you how many stock-length bars to buy.

It keeps the bars back from the slab edge (concrete cover) and fits several short bars onto each stock length where possible.

Worked examples

InputsResult
UnitsImperial (ft, in)Slab length (ft or m)20Slab width (ft or m)10Bar spacing (in or cm)12Edge clearance (in or cm)3Stock bar length (ft or m)20Stock bars to buy: 20Lengthwise: 10 bars × 19 ft 6 inWidthwise: 20 bars × 9 ft 6 inTotal rebar: 385 ft (117.35 m)
Show 2 more examples
UnitsImperial (ft, in)Slab length (ft or m)24Slab width (ft or m)24Bar spacing (in or cm)16Edge clearance (in or cm)3Stock bar length (ft or m)20Stock bars to buy: 44Lengthwise: 18 bars × 23 ft 6 inWidthwise: 18 bars × 23 ft 6 inTotal rebar: 846 ft (257.86 m)Some bars are longer than stock: add lap splices (about 40 × bar diameter) to the order.
UnitsMetric (m, cm)Slab length (ft or m)6Slab width (ft or m)4Bar spacing (in or cm)30Edge clearance (in or cm)7.5Stock bar length (ft or m)6Stock bars to buy: 33Lengthwise: 13 bars × 5.85 mWidthwise: 20 bars × 3.85 mTotal rebar: 153.05 m (502.13 ft)

Stock bars to buy by bar spacing

With the calculator's starting values, the stock bars to buy is 20. The table shows how it changes with the bar spacing.

Bar spacing (in)Stock bars to buy
640
830
1024
12starting value20
1418
1616
1814

Other inputs: Units: Imperial (ft, in) · Slab length: 20 ft · Slab width: 10 ft · Edge clearance: 3 in · Stock bar length: 20 ft. Change them in the calculator above for your own numbers.

How it works

Bars running the long way are spaced across the width: ⌊(width − 2 × cover) ÷ spacing⌋ + 1 bars, each length − 2 × cover long. Bars running the short way are spaced along the length in the same way. Stock bars are counted by how many cut bars fit on each.

The formula

Bars = ⌊(Side − 2 × Cover) ÷ Spacing⌋ + 1 · Bar length = Other side − 2 × Cover
SpacingCentre-to-centre distance between bars
CoverConcrete between the slab edge and the first bar

Practical tips

  • Support rebar on chairs so it sits in the middle third of the slab, not on the ground.
  • Where bars must be joined, overlap them about 40 bar diameters (20 in for #4 bar).
  • Wire the grid at every other intersection so it does not shift during the pour.

Frequently asked questions

What rebar spacing should a driveway use?

A common choice is #4 bar at 12–18 in on centre each way, but check local requirements.

How much cover does rebar need?

About 3 in against soil and 1½–2 in elsewhere in typical residential concrete.