Overview

This calculates how much water a pipe holds, handy for flushing lines, sizing expansion tanks or adding chemical treatments.

Enter the inside diameter, not the nominal size, and the length. Real inside diameters depend on the pipe type.

Worked examples

InputsResult
UnitsImperial (ft, miles, gallons)Inside diameter (in or cm)2Length (ft or m)100Volume: 16.32 US gallonsIn liters: 61.8 LWater weight: 136 lb
Show 2 more examples
UnitsImperial (ft, miles, gallons)Inside diameter (in or cm)4Length (ft or m)50Volume: 32.64 US gallonsIn liters: 123.6 LWater weight: 272 lb
UnitsImperial (ft, miles, gallons)Inside diameter (in or cm)0.75Length (ft or m)200Volume: 4.59 US gallonsIn liters: 17.4 LWater weight: 38 lb

Volume by inside diameter

With the calculator's starting values, the volume is 16.32 US gallons. The table shows how it changes with the inside diameter.

Inside diameter (in)Volume (US)
14.08 US gallons
1.256.37 US gallons
1.59.18 US gallons
1.7512.49 US gallons
2starting value16.32 US gallons
2.2520.65 US gallons
2.525.5 US gallons
2.7530.85 US gallons
336.72 US gallons

Other inputs: Units: Imperial (ft, miles, gallons) · Length: 100 ft. Change them in the calculator above for your own numbers.

How it works

A pipe is a cylinder, so its volume is π times the radius squared times length. Dividing cubic inches by 231 gives US gallons. Doubling the diameter holds four times as much, as the area depends on the square of the diameter. Fresh water weighs about 8.34 lb per gallon.

The formula

Gallons = π × (d ÷ 2)² × length × 12 ÷ 231
dInside diameter in inches
lengthIn feet

Practical tips

  • 100 ft of 2 in pipe holds about 16.32 gallons, which weighs about 136 lb.
  • Check that supports can carry the weight of pipes full of water.
  • Nominal 2 in pipe is rarely exactly 2 in inside, so check the spec.

Frequently asked questions

What is nominal pipe size?

A label that’s only roughly the real diameter. The true inside diameter depends on type and wall thickness.

How do I measure the volume of a whole system?

Add up each section of pipe, then add tanks and heaters.