Overview

Most older attics are under-insulated. This calculator shows how many extra inches of insulation reach your target R-value and the volume to order.

Enter the R-value you are aiming for, what is already there and the insulation type you plan to add.

Worked examples

InputsResult
UnitsImperial (ft, miles, gallons)Target R-value49Existing R-value11Insulation typeBlown cellulose (R-3.5/in)Attic floor area (ft² or m²)1,000Add 10.9 in of insulation (27.6 cm)Volume: 904.76 ft³ (25.62 m³)Adds R-38 for a total of R-49
Show 2 more examples
UnitsImperial (ft, miles, gallons)Target R-value38Existing R-value0Insulation typeBlown fiberglass (R-2.5/in)Attic floor area (ft² or m²)1,200Add 15.2 in of insulation (38.6 cm)Volume: 1,520 ft³ (43.04 m³)Adds R-38 for a total of R-38
UnitsImperial (ft, miles, gallons)Target R-value60Existing R-value19Insulation typeFiberglass batts (R-3.1/in)Attic floor area (ft² or m²)800Add 13.2 in of insulation (33.6 cm)Volume: 881.72 ft³ (24.97 m³)Adds R-41 for a total of R-60

Attic Insulation by target r-value

With the calculator's starting values, the result is Add 10.9 in of insulation. The table shows how it changes with the target r-value.

Target R-valueAttic Insulation
30Add 5.4 in of insulation
40Add 8.3 in of insulation
49starting valueAdd 10.9 in of insulation
50Add 11.1 in of insulation
60Add 14 in of insulation
70Add 16.9 in of insulation

Other inputs: Units: Imperial (ft, miles, gallons) · Existing R-value: 11 · Attic floor area: 1,000 ft². Change them in the calculator above for your own numbers.

How it works

Insulation R-values add up. The extra R needed is the target minus the existing R-value; dividing by the R-value per inch of the chosen material gives the depth to add, and depth × area gives the volume.

The formula

Depth = (Target R − Existing R) ÷ R per inch
R per inchBlown fiberglass ≈ 2.5, cellulose ≈ 3.5, fiberglass batts ≈ 3.1, mineral wool ≈ 3.3

Practical tips

  • Seal air leaks around lights, pipes and the attic hatch before adding insulation.
  • Keep insulation clear of eave vents with baffles so the roof can breathe.
  • Blown insulation settles; manufacturers quote a settled depth on the bag chart.

Frequently asked questions

What R-value should my attic have?

The US Department of Energy recommends R-30 to R-60 depending on climate zone; R-49 is typical for cold climates.

How deep is R-38?

About 15 in of blown fiberglass or 11 in of cellulose.