Overview
A gear ratio compares the size of your chainring with the cog you are riding. Higher ratios are harder to turn but take you further with each pedal stroke.
Enter your chainring, cog, wheel size and cadence to get the ratio, gear inches, development and speed.
Worked examples
| Inputs | Result |
|---|---|
| Chainring teeth50Cog teeth17Wheel circumference (mm)2,096Cadence (rpm)90 | Gear ratio: 2.94Gear inches: 77.3Development: 6.16 m per pedal turnSpeed at 90 rpm: 33.3 km/h (20.7 mph) |
Show 2 more examples
| Chainring teeth39Cog teeth25Wheel circumference (mm)2,105Cadence (rpm)80 | Gear ratio: 1.56Gear inches: 41.2Development: 3.28 m per pedal turnSpeed at 80 rpm: 15.8 km/h (9.8 mph) |
| Chainring teeth52Cog teeth11Wheel circumference (mm)2,096Cadence (rpm)100 | Gear ratio: 4.73Gear inches: 124.2Development: 9.91 m per pedal turnSpeed at 100 rpm: 59.5 km/h (36.9 mph) |
Gear ratio by cog teeth
With the calculator's starting values, the gear ratio is 2.94. The table shows how it changes with the cog teeth.
| Cog teeth | Gear ratio |
|---|---|
| 9 | 5.56 |
| 12 | 4.17 |
| 15 | 3.33 |
| 17starting value | 2.94 |
| 18 | 2.78 |
| 21 | 2.38 |
| 24 | 2.08 |
Other inputs: Chainring teeth: 50 · Wheel circumference: 2,096 mm · Cadence: 90 rpm. Change them in the calculator above for your own numbers.
How it works
The gear ratio is chainring teeth divided by cog teeth. Development is the ratio times the wheel circumference: how far you travel per pedal turn. Speed is development × cadence.
The formula
| Gear inches | Ratio × wheel diameter in inches, a traditional way to compare gears |
Practical tips
- A 50×17 gear on a 2,096 mm wheel has a ratio of 2.94, a development of 6.16 m and a speed of 33.3 km/h at 90 rpm.
- A comfortable cadence is usually 80–100 rpm on the road.
- Gear inches of 60–80 suit most road riding; track and fixed riders often use a similar range.
Frequently asked questions
How do I find my wheel circumference?
Mark the tire and floor, roll one full turn and measure, or check the tire size chart; 700×25c is about 2,096 mm.
What gearing do I need for hills?
Lower ratios (below about 1.5) make steep climbs easier.